These couple of photos should wrap up my posts on the Australian Historical 18-footer visit to Annapolis.
The 1932 reproduction Aberdare rolled on her side. You can make out the moderate V section shape which is not too dissimilar to the section shape of the 1870 Sandbaggers (though every thing else on the hull shape is completely different).
Australia IV before the mast went up. The reproduction 18-footers are cold molded in plywood with an outer layer of cedar. The originals were built single planked, bent nailed into interior seam stringers (batten seam construction). The reproduction hulls weigh around 270 kg (600 lbs.), which seems to be about 100 kg less than the original hulls.
The daggerboards are simple metal plates.
The two architects of the Australian Historical 18-footer visit; Lee Tawney of the National Sailing Hall of Fame and Ian Smith of the Historical 18-footer organization. Ian Smith has written a book on the old Australian 18-footers; half the book is a history, the other half a construction primer on how they were built. The blogmeister bought the book and can vouch that "The Open Boat" is well worth adding to your yachting book collection.
Masts are raised on a tabernacle which makes it a simple task. The reproduction 18-footers have aluminum spars. The amount of old and new that is allowed on the reproduction 18-footers is arrived at by consensus among the fleet. One thing is clear, these vintage reproductions are not babied, either on the beach or on the water.
Still trying to keep the plastic use down...
3 hours ago